LEDGlow Advanced 3 Million Truck LED Underbody Kit - Manual (Page 5)


Setting the Kit to a Solid Color and Creating Custom Solid Colors
o Setting the Kit to a Solid Color Mode
 Press the P1 button to your desired preset number.
 Once you have selected your desired preset position, press and hold the P2 button until the “1” flashes on the
control box display.
 Now that the number “1” is flashing in the P2 position on the display, press the P3 button until the display reads
0 in the P4 position.
 Now press the P2 button until a “3” is flashing in the P2 position on the control box display
 Once a “3” is displayed in the P2 position on the control box display, you can press the P4 button to cycle
through all solid color modes. Note: Reference the numerical chart above for each solid color mode display
number.
o Creating a Custom Solid Color
 You must be in the Solid Color Mode explained above to create custom colors. Once you are in the solid
color selecting the mode explained above, press the P4 button until a “19” is displayed in the P4 position on the
control box display. This will put the kit into a Million Color Fade Mode.
 While you are in this mode, you can press the P3 button any time to pause the kit when you find your desired
color. The auto save feature will automatically save your color to your selected preset number.
1. Note: You can double press the P3 button to slowly step between each color, giving you more
control over your color selection.
2. Note: Your custom color will automatically save to the preset number you selected on the P1
display.

Restoring the Kit Back to Factory Settings
o Turn the kit off, then press and hold the P4 button for 3 seconds.
o When the display is flashing with a “1”, the factory defaults have been restored.

Wireless Remote Functions
o The included wireless remote only allows you to turn the kit ON/OFF,
cycle through saved patterns, as well as put the kit into Sound Activation
Mode.
o Note: To customize patterns and colors, you MUST use the Control
Box.
1. Powers the Kit ON/OFF
2. Turns Sound Activation Mode ON/OFF
3. Cycles Through Preset/Saved Patterns
4. Not Used

Reprogramming the Wireless Remote to the Control Box
o If you lost or need to replace your wireless remote, follow the instructions below:
 Turn the kit OFF by pressing the P1 button.
 Press and hold the #3 button on the wireless remote while holding the P2 button down on the control box.
 The control box will quickly flash “0000” on the display if successful.

Adding Additional Underbody, Interior or Wheel Well Tubes to your Control Box
o This underbody kit can power and unlimited amount of add-on tubes whether it is underbody, interior or wheel well tubes.
o To power the additional tubes, simply connect them to your existing USB hub. Each USB hub can power a total of 6 tubes.
o Note: If all the USB ports are being used on the hub, connect the add-on USB hub that came with your add-on kit to
your existing USB hub using the included linking cable.