ZOLL AED Pro Rev A - Manual (Page 16)

C
HAPTER
1 M
AINTENANCE
T
ESTS
1–4 www.zoll.com 9650-0309-01 Rev. A
2.0 Preventive Maintenance Test
Use this test to verify that the AED Pro unit is working properly and ready for use.
For an alternative test using the AED Pro simulator, refer to the AED Pro Operator’s Guide.
Note: To verify that the delivered energy for the first, second, and third shocks corresponds
to the unit’s preconfigured adult energy levels, use the ZOLL Administration Software
(ZAS) to obtain the current configuration of the unit.
Tools Needed
• Fluke Impulse 4000 Defibrillator/Pacer Performance Analyzer or equivalent
• Defibrillation analyzer (universal) adapter cable
Test Setup
• Turn off the AED Pro unit and unplug the preconnected electrodes. Keep the electrodes so
they can be reconnected later.
• Connect the universal adapter cable to the AED Pro unit and to the analyzer.
• Turn on the analyzer and set its function to VF (ventricular fibrillation).
Variations in Messages
When verifying messages in the test results, please be aware of the following issues:
• The wording of some messages is configurable. The following table shows equivalent
messages.
• The message that reports the detected electrode type can be either ADULT PADS,
PEDIATRIC PADS, or ECG CABLE.
• Some messages are issued only if the unit is configured to do so. If an optional message is
not issued during a test, do not consider this a failure.
• In some cases a text message on the display screen is abbreviated or otherwise differs
slightly from the associated voice message.
Default Message Alternative Message
CHECK PATIENT CHECK RESPONSIVENESS
CHECK PULSE CHECK CIRCULATION
IF NO PULSE START CPR IF NO CIRCULATION START CPR
IF NO PULSE CONTINUE CPR IF NO CIRCULATION CONTINUE CPR
SHOCK ADVISED TREATMENT ADVISED
NO SHOCK ADVISED NO TREATMENT ADVISED
PRESS FLASHING SHOCK BUTTON PRESS FLASHING TREATMENT BUTTON
RELEASE SHOCK BUTTON RELEASE TREATMENT BUTTON
SHOCK DELIVERED TREATMENT DELIVERED
NO SHOCK DELIVERED NO TREATMENT DELIVERED