Actiontec electronic Wireless DSL Gateway GT704WG-QW04 User Manual
Page 29
26
Actiontec DSL Gateway User Manual
27
Chapter 4 Configuring Advanced Settings
Obtain an IP Address through PPPoE or PPPoA
Select one of these options to allow the Gateway to use the Point-to-Point over
Ethernet (
PPPoE
) or Point-to-Point over
ATM
(
PPPoA
) protocol.
“Broadband Connection via PPPoE” screen:
“Broadband Connection via PPPoA” screen:
If a User Name and Password was entered in the Installation Buddy or during
Basic Setup, it should be displayed in the “Broadband Connection via
PPP
o
E/
PPP
o
A
” screen. If not, enter the information now. If the
ISP
does not require a
username or password, click in the box next to “My
ISP
does not require a user-
name and password.”
PPP Auto Connect
If
PPP
auto connect is activated (by clicking in the appropriate check box), the
Gateway will attempt to automatically reconnect the
PPP
connection if it is
dropped or disconnected during an online session.
PPP
Auto Connect is turned on
by default.