Actiontec electronic Wireless DSL Gateway GT704WG-QW04 - Manual (Page 39)

36
Actiontec DSL Gateway User Manual
37
Chapter 4 Configuring Advanced Settings
DHCP Server Configuration
Clicking Next in the “ DHCP Server” screen generates the “ DHCP Server Settings”
screen. Change IP address range and DNS server information here.
Beginning IP Address, Ending IP Address
These are the
IP addresses at which the DHCP server starts and stops assigning IP
addresses. Actiontec recommends keeping the factory default settings for these
IP addresses (192.168.0.2 and 192.168.0.254, respectively).
The beginning and ending IP addresses define the IP address range of the
Gateway. If the default values are left intact, the Gateway supplies a unique IP
address between 192.168.0.2 and 192.168.0.254
to each computer on the net-
work. Note that the first three groups of numbers of the addresses are identical;
this means they are on the same subnet. The
IP address of the Gateway must
be on the same subnet as the IP address range it generates. For instance, if the
Gateway’s IP address is changed to 10.33.222.1, set the beginning IP address to
10.33.222.2, and the ending IP address to 10.33.222.254.
DNS (Dynamic or Static)
This is the type of
DNS server provided by the ISP . If the ISP provided DNS serv-
er information, select the type here. If not, leave as is.
DNS Server 1
The primary
DNS server provided by the ISP . If the ISP provided DNS server
information, enter it here. If not, leave the text box intact.
DNS Server 2
The secondary
DNS provided by the ISP . If the ISP provided secondary DNS
server information, enter it here. If not, leave the text box intact.