Technical support – Actiontec electronic Wireless DSL Gateway GT704WG-QW04 User Manual
Page 9
6
Actiontec DSL Gateway User Manual
7
Chapter 1 Introduction
Reset Switch
Depressing the Reset switch for one or two seconds will power cycle the Gateway
(similar to unplugging and then plugging in the Gateway’s Power cord). To
restore the Gateway’s factory default settings, depress and hold the Reset switch
for approximately 10 seconds. The reset process will start about
10
seconds after
releasing the switch.
Power Port
The Power port is used to connect the Power cord to the Gateway.
N
Warning: Do not unplug the Power cord from the Gateway
during the reset process. Doing so may result in permanent
damage to the Gateway.
Power Switch
The Power switch is used to power the Gateway on and off.
Technical Support
Basic Setup Support
If unable to access the Internet, look at the Internet light on the front of the
Gateway. If the light is solid green, call the
ISP
immediately. If it is not solid
green, call Qwest at 1-800-247-7285
Other Problems
Contact the
ISP
if experiencing problems with:
s
DHCP
addressing configuration
s
Static
IP
addressing configuration
s
Transparent bridging configuration
Contact Qwest at 1-800-247-7285 for:
s
DSL
service outage support and repair
s
DSL
service installation support