Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 135)

Brocade Mobility RFS Controller System Reference Guide 123
53-1003099-01
5
19. Select the Advanced Settings tab.
FIGURE 47 Profile Overrides - Access Point Radio Advanced Settings tab
20. Refer to the Aggregate MAC Protocol Data Unit (A-MPDU) field to define or override how MAC
service frames are aggregated by the Access Point radio.
21. Use the A-MSDU Modes drop-down menu in the Aggregate MAC Service Data Unit (A-MSDU)
section to set or override the supported A-MSDU mode.
Available modes include Receive Only and Transmit and Receive. Transmit and Receive is the
default value. Using Transmit and Receive, frames up to 4 KB can be sent and received. The
buffer limit is not configurable.
A-MPDU Modes Use the drop-down menu to define the A-MPDU mode supported. Options include Transmit Only,
Receive Only, Transmit and Receive and None. The default value is Transmit and Receive. Using the
default value, long frames can be both sent and received (up to 64 KB). When enabled, define either a
transmit or receive limit (or both).
Minimum Gap Between
Frames Use the drop-down menu to define the minimum gap between A-MPDU frames (in microseconds). The
default value is 4 microseconds.
Received Frame Size
Limit If a support mode is enabled allowing A-MPDU frames to be received, define an advertised maximum
limit for received A-MPDU aggregated frames. Options include 8191, 16383, 32767 or 65535 bytes.
The default value is 65535 bytes.
Transmit Frame Size
Limit Use the spinner control to set a limit on transmitted A-MPDU aggregated frames. The available range is
from 2,000 - 65,535 bytes. The default value is 65535 bytes.