Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 435)

Brocade Mobility RFS Controller System Reference Guide 423
53-1003099-01
8
19. Refer to the Aggregate MAC Protocol Data Unit (A-MPDU) field to define how MAC service
frames are aggregated by the Access Point radio.
20. Use the A-MSDU Modes drop-down menu in the Aggregate MAC Service Data Unit (A-MSDU)
section to set the supported A-MSDU mode.
Available modes include Receive Only and Transmit and Receive. Transmit and Receive is the
default value. Using Transmit and Receive, frames up to 4 KB can be sent and received. The
buffer limit is not configurable.
21. Set the following Aeroscout Properties:
22. Set the following Ekahau Properties:
Set the following Non-Unicast Traffic values for the profile’s supported Access Point radio and its
connected wireless clients:
A-MPDU Modes Use the drop-down menu to define the A-MPDU mode supported. Options include Transmit Only,
Receive Only, Transmit and Receive and None. The default value is Transmit and Receive. Using the
default value, long frames can be both sent and received (up to 64 KB). When enabled, define either a
transmit or receive limit (or both).
Minimum Gap Between
Frames Use the drop-down menu to define the minimum gap between A-MPDU frames (in microseconds). The
default value is 4 microseconds.
Received Frame Size
Limit If a support mode is enabled allowing A-MPDU frames, define an advertised maximum limit for received
A-MPDU aggregated frames. Options include 8191, 16383, 32767 or 65535 bytes. The default value is
65535 bytes.
Transmit Frame Size
Limit Use the spinner control to set limit on transmitted A-MPDU aggregated frames. The available range is
between 2,000 - 65,535 bytes). The default value is 65535 bytes.
Forward Select enable to forward Aeroscout packets to a specified MAC address. Aeroscout tags associate with
an Access Point, then communicate with a location engine. This setting is disabled by default.
MAC to be forwarded Specify the MAC address to be forwarded.
Forward Host Specify the Ekahau engine IP address. Using Ekahau small, battery powered Wi-Fi tags are attached to
tracked assets or carried by people. Ekahau processes locations, rules, messages and environmental
data and turns the information into locationing maps, alerts and reports.
Forwarding Port Use the spinner control to set the Ekahau TZSP port used for processing information from locationing
tags.
MAC to be forwarded Specify the MAC address to be forwarded.
Broadcast/Multicast
Transmit Rate Use the drop-down menu to define the data rate broadcast and multicast frames are transmitted.
Seven different rates are available if the not using the same rate for each BSSID, each with a separate
menu.
Broadcast/Multicast
Forwarding Define whether client broadcast and multicast packets should always follow DTIM, or only follow DTIM
when using Power Save Aware mode. The default setting is Follow DTIM.