Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 146)

134 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
5
FIGURE 51 Profile Overrides - Network ARP screen
6. Set or override the following parameters to define the controller or service platform’s ARP
configuration:
7. To add additional ARP overrides click on the + Add Row button and enter the configuration
information in the table above.
8. Select the OK button to save the changes and overrides to the ARP configuration. Select Reset
to revert to the last saved configuration.
Overriding a Profile’s L2TPV3 Configuration
Overriding a Profile’s Network Configuration
L2TP V3 is a standard used for transporting different types of layer 2 frames in an IP network (and
Access Point profile). L2TP V3 defines control and encapsulation protocols for tunneling layer 2
frames between two IP nodes.
Switch VLAN Interface Use the spinner control to select a VLAN interface (1 - 4094) for an address
requiring resolution.
IP Address Define the IP address used to fetch a MAC address.
MAC Address Displays the target MAC address that’s subject to resolution. This is the MAC used
for mapping an IP address to a MAC address that’s recognized on the network.
Device Type Specify the device type the ARP entry supports. Host is the default setting.