Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 966)

954 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
15
FIGURE 149 Access Point - VPN IKESA screen
5. Review the following VPN peer security association statistics:
IPSec
VPN
Use the IPSec VPN screen to assess tunnel status between networked peer.
To view IPSec VPN status for tunnelled peers:
1. Select the Statistics menu from the Web UI.
2. Select System from the navigation pane (on the left-hand side of the screen). Expand a RF
Domain, select a controller or service platform, and select one of its connected Access Points
3. Select VPN and expand the menu to reveal its sub menu items.
4. Select IPSec.
Peer Lists peer IDs for peers sharing security associations (SA) for tunnel interoperability. When a peer sees a
sensitive packet, it creates a secure tunnel and sends the packet through the tunnel to its destination.
Version Displays each peer’s IKE version used for auto IPSec secure authentication with the IPSec gateway and
other controllers or service platforms.
State Lists the state of each listed peer’s security association (whether established or not).
Lifetime Displays the lifetime for the duration of each listed peer IPSec VPN security association. Once the set
value is exceeded, the association is timed out.
Local IP Address Displays each listed peer’s local tunnel end point IP address. This address represents an alternative to
an interface IP address.
Clear All Select the Clear All button to clear each peer of its current status and begin a new data collection.
Refresh Select the Refresh button to update the screen’s statistics counters to their latest values.