Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 162)

150 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
5
2. Select a target device (by double-clicking it) from amongst those displayed within the Device
Configuration screen.
Devices can also be selected directly from the Device Browser in the lower, left-hand, side of
the UI.
3. Select Profile Overrides from the Device menu to expand it into sub menu options.
4. Select Network to expand its sub menu options.
5. Select Spanning Tree.
NOTE
A blue override icon (to the left of a parameter) defines the parameter as having an override applied.
To remove an override go to the Basic Configuration section of the device and click the Clear
Overrides button. This removes all overrides from the device.
FIGURE 61 Spanning Tree screen
6. Set the following MSTP Configuration parameters
MSTP Enable Select this option to enable MSTP for this profile. MSTP is disabled by default, so if
requiring different (groups) of VLANs with the profile supported network segment.
Max Hop Count Define the maximum number of hops the BPDU will consider valid in the spanning
tree topology. The available range is from 7 -127. The default setting is 20.
MST Config Name Define a 64 character maximum name for the MST region as an identifier.