Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 204
192
Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
5
If any of the required values within the step 2 screen are not set properly, the third wizard
screen will not display until they are properly set.
FIGURE 88
VPN Step-By-Step Wizard - Step 3
Set the following IPSec VPN values for step 3:
Transform Set
The transform set is a set of configurations for creating the VPN tunnel and imposes a security policy on
the tunnel. Primarily, the transform set comprises the following:
•
Encryption – The encryption used for creating the tunnel.
•
Authentication – The authentication used to identify tunnel peers
•
Mode – The mode of the tunnel. This is the tunnel’s operational mode.
From the drop-down, select any pre-configured Transform Set or select Create New Policy to create a
new transform set.