KROHNE BM 100A Handbook - Manual (Page 65)

Handbook BM 100 A 65
The following functions are available on the main measurement window page:
F1 – Help Menu
On-line help file
F2 – Configuration Menu:
For creating and modifying gauge settings while PCSTAR is connected to the gauge. The
configuration may also be created, modified or saved without sending the new settings to the gauge
in this window. The User configuration menu will be listed as shown in Section 3.4.5 of this manual.
The values displayed will be either default or customer-order specified values. Follow the instructions
in this section to configure the gauge.
Functions available on this page (use scroll slider on the right hand side to show all):-
User functions 1.1.1 to 1.1.7 : Basic Parameters
User functions 1.2.1 to 1.2.6 : Display Parameters
User functions 1.3.1 to 1.3.8 : Current Output Parameters
User functions 1.4.1 to 1.4.9 : User Data Parameters
User functions 1.5.1 to 1.5.9 : Application Parameters
User functions 1.6.1 to 1.6.2 : Serial Input/Output Parameters
User functions 1.7.1 to 1.7.3 : Strapping Table Parameters and…
F1 – Help :
F2 – Load from disk :
F3 – Exit:
F4 – Load from BM100:
F5 – Save to disk:
F6 – Send to BM100:
On-line help file
This loads old settings from the hard disk onto PCSTAR (not to gauge).
Exit configuration page to real-time measurement main window.
This loads the configuration currently used by the gauge into PCSTAR
Press to save a configuration onto disk in *.KRF format. This allows the
user to load old configurations later and also facilitates analysis of the
gauge by KROHNE personnel if a problem is encountered.
Press this once all configuration parameters have been entered. This will
load the new configuration into the gauge.