SHIMPO DT-365 - Manual (Page 14)

14
Emission duration mode 4.3.5
The emission time (ratio) can be set by 0.1º within the range between 0.1º/ 360º and 3.6º/ 360º in
the emission duration mode (DUR). The emission time setting value shows the strobe emitting
time by angle while a rotating object rotates one revolution (360º).
While the “UNIT” key is being pressed, the value converted from the emission angle to time can be
checked.
A longer emission time increases the brightness, but a measured object appears to be moving.
Also, a shorter emission time decreases the brightness, but a measured object appears to stand
more still.
Adjust the appropriate emission time according to your application and conditions and use the unit.
Press the MODE key to switch to the phase mode (PHA).
Operation Display
Increase/decrease
the emission angle
Indicates the
emission time while
the key is being
pressed
Emission angle: Decreases Emission angle: Increases
Indicates the value converted
from the emission angle to time Indicates the value converted
from the emission angle to time
CW CCW
Press the key to
switch to the phase
mode
Emission duration mode Phase mode