SHIMPO DT-365 - Manual (Page 15)

15
Phase mode 4.3.6
When the rotation (motion) cycle of a measured object matches with the strobe flash cycle, the
measured object appears to stand still. To change the angle (position) to make the object stand
still, use the phase mode.
The phase can be changed by 0.1º using the dial within the range between 1º and 359º in the phase
mode (PHA).
Press the UNIT key to set the phase change by time. The phase can be changed by 1 ms within
the range between 0 ms and 999 ms (max.).
When time is used for setting, a longer time duration than the emission cycle cannot be set.
Press the MODE key to switch to the emission count mode (FPM).
Operation Display
Increase/decrease
the delay angle
Each press switches
the delay time
display
Delay angle: Decreases Delay angle: Increases
Delay time: Decreases Delay time: Increases
CCW
CW
CCW
CW
Press the key to
switch to the emission
count mode
Phase mode Emission count mode