SHIMPO DT-365 - Manual (Page 5)

5
Peel off the protection sheet 2.2
Peel off the protection sheet on the operation section.
Operation section
Peel off the (transparent)
protection sheet
Charging (only for DT-365) 2.3
Be sure to charge the battery before initial use. Before charging, be sure to check that the power is
turned OFF.
Charging method 2.3.1
Turn the power OFF and connect the supplied AC adapter's connector to the main unit. Next insert
the AC adapter's AC plug into an outlet. The battery lamp lights up and charging starts.
Charging is complete in approximately 2.5 hours. Then the battery charging lamp turns off.
* Be sure to use only the supplied AC adapter.
When the power is turned ON with the supplied AC adapter connected, charging ends and
operation starts.
* Note that operation and charging cannot be performed simultaneously.
Connect the supplied AC adapter
Note 1) Since the battery current is automatically shut off when charging is complete, there is no need
to worry about overcharging.
Note 2) When the power is turned ON during charging, charging is canceled and emission starts. When
the unit uses the AC adapter as its power source, it is not charged.
Note 3) To extend battery life and charging capacity, it is recommended to deplete the battery fully
before charging. ( LLLLLL is indicated on the number display)
Note 4) If the unit is charged immediately after long periods of usage at a high ambient temperature,
the temperature rise protection circuit will turn on and the charging lamp may not light up. In
that case, disconnect the AC adapter and let the unit cool. When the product temperature is
decreased, connect the AC adapter again to start charging.
Note 5) Never charge the unit under the following conditions.
Adapter of
another device
Charging near flammable materials Using another AC adapter than supplied.
Oil