SHIMPO DT-365 - Manual (Page 18)

18
Phase mode 4.4.3
Delay emission can be set within the input signal range between 60 fpm and 10,000 fpm.
In the phase mode (PHA), the delay angle from the external pulse entry to strobe flash emission
can be changed by 0.1º using the dial within the range between 1º and 359º.
Press the UNIT key to set the phase change by time. The phase can be changed by 1 ms within
the range between 0 ms and 999 ms (max.).
When time is used for setting, a time longer than the emission cycle cannot be set.
Press the MODE key to switch to the emission count mode (FPM).
* When the external synchronous signal has not been entered, [ _ _ _ _ _ _ ] and the delay setting values
are indicated alternately.
When the external synchronous signal has been entered, only the delay setting value is indicated.
Operation Display
Increase/decrease
the delay angle
Each press switches
the delay time
display
Delay angle: Decreases Delay angle: Increases
Delay time: Decreases Delay time: Increases
CCW
CW
CCW
CW
Press the key to
switch to the phase
mode
Phase mode Emission count mode