SHIMPO DT-365 - Manual (Page 9)

9
Functions and operations 4
Power ON/OFF 4.1
Press the power switch when the power is OFF to turn the power ON.
When the power is turned ON, the model is indicated, followed by internal oscillation emission or
external synchronous emission.
Operation Display
When the power is
OFF
Press the power
switch
The screen of internal oscillation
emission is indicated and emission
starts.
Internal oscillation emission
when the power was last OFF
External synchronous emission
when the power was last OFF
The screen of external synchronous
emission is indicated and the unit
enters the standby mode for the
external signal.
* When DT-365 is used, the indication may go off immediately after the power is turned ON. In that case,
charge the unit because the remaining battery level is low. For details about charging, refer to 2.3
Charging
.
Press the power switch when the power is ON to turn the power OFF, then the indication goes off.
Operation Display
When the power is ON
Press the power
switch
Indicated letters go off.
* When the power is turned ON, the following indication may be displayed.
The following is the error message showing EEPROM read failure. Press the x2 key to return to the normal
emission screen from the error message display.
Operation Display
Press the x2 key Returns to the normal
setting screen
Error display
EEPROM read failure