SHIMPO DT-365 - Manual (Page 3)

3
- Contents -
1 Overview 4
2 Before use 4
2.1 Checking accessories 4
2.2 Peel off the protection sheet 5
2.3 Charging (only for DT-365) 5
2.3.1 Charging method 5
2.3.2 Indication of low battery voltage 6
2.3.3 Battery replacement 6
3 Part names and functions 7
3.1 Main unit 7
3.2 Operation section 7
3.3 Display 8
3.3.1 Part names 8
3.3.2 Number display 8
3.3.3 Unit display 8
3.3.4 Emission setting display 8
3.3.5 Mode display 8
3.3.6 Memory number display 8
3.3.7 Charging lamp (only for DT-365) 8
4 Functions and operations 9
4.1 Power ON/OFF 9
4.2 Emission setting 10
4.3 Internal oscillation emission 11
4.3.1 Display of internal oscillation emission 11
4.3.2 Switching the modes 11
4.3.3 Switching the unit display 11
4.3.4 Emission count mode 12
4.3.4.1 Emission count setting 12
4.3.4.2 Changing the emission count (frequency) to double or half 13
4.3.5 Emission duration mod 14
4.3.6 Phase mode 15
4.4 External synchronous emission 16
4.4.1 Emission count mode 16
4.4.2 Emission duration mode 17
4.4.3 Phase mode 18
4.4.3.1 How to set the delay 19
4.5 Memory function 20
4.5.1 Saving each setting value 20
4.5.1.1 Saving on internal oscillation emission 21
4.5.1.2 Saving on external synchronous emission 22
4.5.1.3 Saving the setting value when the power is OFF 22
4.5.2 Reading out each setting value 23
4.5.2.1 Reading out on internal oscillation emission 23
4.5.2.2 Reading out on external synchronous emission 24
4.6 Function mode 25
4.6.1 Moving to the function mode 25
4.6.2 Measurement range setting (Function mode 1) 26
4.6.3 Trigger edge setting (Function mode 2) 27
4.6.4 Auto emission stop time setting (Function mode 3) 29
4.6.5 Input signal setting (Function mode 4) 30
4.7 External I/O connector 31
4.7.1 Specifications for external I/O connector and pin assignment 31
4.7.2 External pulse input 32
4.7.3 External trigger pulse output 32
5 Specifications 33
6 External dimensions 34
7 Trouble shooting 35