SHIMPO DT-365 - Manual (Page 2)

2
Safety Requirements
Be sure to observe
Before operation, maintenance and inspection, please carefully read this instruction manual and
follow it for proper use. Please carefully read all information related to this unit's safety precautions
before use.
This instruction manual provides two grades of safety warnings: Danger and Caution.
Each of them is an important description related to safety. Be sure to follow them.
DANGER
This indicates the possibility of fire, severe injury and even death if a user disregards the instruction
and operates the unit improperly.
CAUTION
This indicates a potential situation that could produce a minor injury or damage to material if it is
improperly handled.
However, depending on the circumstances, there could be a possibility that it may cause more
serious results. Be sure to follow them.
Protection categories are explained and separated by the following symbols
Not allowed -prohibited
Mandatory Must follow
DANGER
Do not use this product in an atmosphere
with risk of fire and/or explosion.
Failure to follow this could result in fire.
Do not look directly at the light emitting
section.
Failure to follow this could result in injury to the eyes.
CAUTION
Do not apply strong impact to the unit, or
drop it.
Failure to follow this could result in abnormal
operation.
Do not use and/or store the unit in the
following places.
•Where water may come in contact
•Where direct sunlight come in contact
•Where high humidity environment may be present
•Where dust, dirt, salt, and/or iron may be present
•Where oil, water, and/or chemicals come in contact
•Where a fire or explosion may exist or occur.
Never disassemble, repair, and remodel
the unit.
Failure to follow this could result in injury due to
abnormal operation.
Use the unit within the proper operating
temperature range (32 - 95F).
Failure to follow this could result in malfunction.
Wipe clean the unit with a soft dry cloth if it gets dirty.
Or immerse a cloth in water diluted neutral detergent,
wring it, and wipe clean the unit with it.
Do not use any volatile chemicals, such as benzene,
thinner, or alcohol.
Use the unit within the proper operating
humidity range (35 - 85%RH). (No
condensation)
Failure to follow this could result in malfunction.
Since continuously emitting light for long time
causes the unit's housing to be very hot, fix
the LED strobe using a tripod, etc. and use the
unit (avoid direct skin contact with the unit,
such as holding it by hand).
Failure to follow this could result in mild burns.