Milestone M50 - Manual (Page 163)

Milestone Husky M30/M50 Administrator's Manual
www.milestonesys.com 163 Advanced configuration
Name Description
Add
Lets you add slave servers. Select Master Server in the list and
click the Add button.
When you select Master Server, the Delete button is disabled and the Add button is enabled
(provided you have selected Enabled as master server). This allows you to add slave servers to the
master server, but prevents your from deleting the master server.
Slave server properties
Name Description
Address IP address of the slave server.
Port Port number of the slave server.
Delete
Remove a slave server from the list of slave servers. Select the
slave server in the list and click the Delete button.
If you want a slave server to become a master server, clear Enable as master server on the original
master server and click OK. In the Management Application's navigation pane, right-click the slave
server which you want to become master server and select Properties. Then select Enable as
master server. Next click Add to add slave servers to the new master server.
Update status on slaves
In the Master Settings Summary and Slave Settings Summary table area, you can verify/update
added slaves by clicking Update Status. A status dialog runs and afterwards informs you of the status
of your slave server(s).
If you select Pre version 8.0 slaves, it is not possible to update slave status on any slaves and
Update Status is therefore disabled. In the Slave Settings Summary table, slave status on all slaves
is Not applicable.
If you do not select Pre version 8.0 slaves, slave status for pre version 8.0 slaves is Unreachable.
Slave status for 8.0 slaves and beyond reflects the actual status.
Users
About users
The term users primarily refers to users who connect to the surveillance system through their clients.
You can configure such users in two ways:

As basic users, authenticated by a user name/password combination.

As Windows users, authenticated based on their Windows login