Milestone M50 - Manual (Page 83)

Milestone Husky M30/M50 Administrator's Manual
www.milestonesys.com 83 Advanced configuration
Name Description
Record All Frames on
Allows you to make exceptions if you have selected to record
keyframes only.

Motion Detection: Select this to record all frames when
motion is detected. Two seconds after the last motion (see
"Motion detection & exclude regions" on page 95) is
detected, the camera will return to recording keyframes
only.

Event: Select this to record all frames when an event
occurs and until another event occurs. Requires that events
have been defined, and that you select start and stop
events in the neighboring columns.
Tip: If you have not yet defined any suitable events, you
can quickly do it: use the Configure events list, located
below the other fields.

Motion Detection & Event: Select this to record all frames
when motion is detected, or when an event occurs and until
another event occurs. Remember to select start and stop
events in the neighboring columns.

Schedule only: Select this to record all frames according to
the camera's speedup schedule (see "Speedup" on page
135) only.
Start Event
Use when recording on Event or Motion Detection & Event.
Select required start event. The camera will begin recording all
frames when the start event occurs.
Stop Event
Select required stop event. The camera will again only recording
keyframes when the stop event occurs.
Audio recording
When you configure video and recording (see "About video and recording configuration" on page 64)
for specific cameras, you can determine whether audio should be recorded or not. Your choice applies
for all cameras on your Milestone Husky product system.
Name Description
Always Always record audio on all applicable cameras.
Never
Never record audio on any cameras. Note that even though audio is
never recorded, it is still be possible to listen to live audio in the
Smart Client.
If you record audio, it is important that you note the following:

Audio recording affects video storage capacity: Audio is recorded to the associated camera’s
database. Therefore, it is important to bear in mind that the database is likely to become full