Milestone M50 - Manual (Page 166)

Milestone Husky M30/M50 Administrator's Manual
www.milestonesys.com 166 Advanced configuration
Configure user and group rights
User/group rights are configured during the process of adding users/groups, see Add basic Users (on
page 164), Add Windows users (on page 164) and Add user groups (on page 165). Note that you can
also add basic and Windows users through the Manage user access wizard (on page 55). However,
when using the wizard all users you add will have access all to cameras, including any new cameras
added at a later stage.
If you at a later stage want to edit the rights of a user or group:
1. In the Management Application's navigation pane, expand Advanced Configuration, expand
Users, right-click the required user or group, and select Properties.
2. Edit General Access (on page 167) and Camera Access (on page 167) properties. These
properties determine the rights of the user/group.
3. Click OK.
4. Save your configuration changes by clicking Save in the yellow notification bar in the upper-
right corner of the Management Application.
User properties
User information
Name Description
User name
Edit the user name. You can only edit this if the selected user is a
Basic user. Names must be unique, and must not contain any of
these special characters: < > & ' " \ / : * ? | [ ]
Password
Only editable if the selected user is of the type basic user. Edit the
password. Remember to repeat the password to be sure you have
specified it correctly.
User type
Non-editable field, displaying whether the selected user is of the
type basic user or Windows user group.
Group information
Name Description
Group name
Edit the group name. Names must be unique, and must not contain
any of these special characters: < > & ' " \ / : * ? | [ ]