Milestone M50 - Manual (Page 62)

Milestone Husky M30/M50 Administrator's Manual
www.milestonesys.com 62 Advanced configuration
to delete the old databases, you must delete this manually. New databases will, of course,
be created for future recordings by the new hardware devices.
4. Click Finish.
When you are ready, restart (see "Start and stop services" on page 170) the Recording Server
service. The hardware replacement are not evident in clients until you restart the Recording
Server service.
Speaker properties
When you configure video and recording (see "About video and recording configuration" on page 64)
for specific cameras, you can determine when to record audio. Your choice applies for all cameras on
your Milestone Husky product system.
Name Description
Enabled
Speakers are by default enabled, meaning that they are able to
transfer audio to Milestone Husky product. If required, you can
disable an individual speaker, in which case no audio will be
transferred from the speaker to Milestone Husky product.
Speaker name
The name as it appears in the Management Application as well as
in clients. You can overwrite the existing name with a new one.
Names must be unique, and must not contain any of these special
characters: < > & ' " \ / : * ? | [ ]
Hardware properties
Hardware name and video channels
When you configure hardware devices (on page 59), specify the following properties:
Name Description
Hardware name
The name as it appears in the Management Application as well as
in clients. You can overwrite the existing name with a new one.
Names must be unique, and must not contain any of these special
characters: < > & ' " \ / : * ? | [ ]
Video channel # enabled
Enable/disable each of the selected hardware device's video
channels. Many hardware devices only have a single video
channel, in which case only one channel will be listed. Other
hardware devices
—typically video encoder devices—have several
video channels.
If some of the channels are unavailable, this is because you are not licensed to use all of a video
encoder device's channels. Example: You have a video encoder device with four channels, but your
license for the device only allows you to use two of them. In that case, you can only have two channels
enabled at a time, while the two other channels are disabled. Note that you are free to select which