Brother SuperGalaxie 3000 3000C 3000D 3100D User Manual
Page 127
3-54
Sewing Utility Stitches
A
6
5
6
5
1
1
2
2. Mark the position and length of the buttonhole on the
fabric.
Note
The maximum buttonhole length is 30 mm (1-3/16 inch)
(diameter + thickness of the button)
3. Attach buttonhole foot “A”. Pull out the button holder
plate on the presser foot, and insert the button that will
be put through the buttonhole, then tighten the button
holder plate around the button.
* The size of the buttonhole is decided by the button
holder plate holding the button.
1 Button holder plate
4. Align the presser foot with the mark on the fabric, and
lower the presser foot lever.
1 Mark on the fabric
2 Mark on the presser foot
CAUTION
• Slide the outside frame of the buttonhole foot back-
ward as far as possible as shown in the illustration,
making sure that there is no gap behind the part of
the foot marked “A”. If the buttonhole foot is not slid
back as far as possible, the buttonhole will not be sewn
with the correct size.
• Pass the thread underneath the presser foot.