Brother SuperGalaxie 3000 3000C 3000D 3100D - Manual (Page 59)

2-2 Getting Ready to Sew
1 —
2 —
3 —
4 —
5 —
6 —
7 —
8 —
?!
9 —
CONTENTS
Index
6
5
7. Press the “Start/Stop” button to begin sewing.
* Guide the fabric lightly by hand.
8. Press the “Start/Stop” button again to stop sewing.
9. Press the “Thread Cutter” button to trim the threads.
* The needle will return to the up position automatically.
CAUTION
Do not press the “Thread Cutter” button after the
threads have been cut. Doing so could tangle the
thread or break the needle and damage the ma-
chine.
CAUTION
• Do not press the “Thread Cutter” button when there
is no fabric set in the machine or during machine op-
eration. The thread may tangle, resulting in damage.
• When cutting thread thicker than #30, nylon thread,
or other decorative threads, use the thread cutter on
the side of the machine.
10.When the needle has stopped moving, raise the presser
foot and remove the fabric.
Note
This machine has a display to warn you when the bobbin
thread has run out. If the warning displays, re-thread the
machine immediately.