P.1-27), Caution – Brother SuperGalaxie 3000 3000C 3000D 3100D User Manual
Page 38
Setting Up
1-27
1
2
3
1
2
2
1
1
7. Use both hands to set the thread around projection in
the thread guides.
1 Projection in the thread guides
8. Pass the thread around the thread guide shaft and the
pretension disk as indicated on drawing. Make sure
that thread is correctly inserted inside the pretension
disk.
1 Thread guide shaft
2 Pretension disk
9. Wind the thread clockwise around the bobbin 4-5 times
(as shown in the illustration).
10.Pass the end of the thread through the guide slit in the
bobbin winder seat, and pull the thread to the right.
The cutter will cut the thread.
1 Guide slit
2 Bobbin winder seat
CAUTION
Be sure to follow the process described. If the
thread is not cut with the cutter, and the bobbin
is wound, when the thread runs low it may tangle
around the bobbin and cause the needle to break.