Caution – Brother SuperGalaxie 3000 3000C 3000D 3100D User Manual
Page 142
Sewing Utility Stitches
3-69
2
3
4
1
5
1
2
3
4
1
2
3
6
1
2
2. Attach presser foot “J” and sew straight stitches up to
the zipper opening. Change to a basting stitch and sew
to the top of the fabric.
1 Reverse stitches
2 Wrong side of fabric
3 Basting stitches
4 End of zipper opening
3. Press the seam allowance open and align the folded
hem along the teeth of the zipper, while maintaining
3 mm (1/8 inch) for the sewing space.
1 Zipper pull tab
2 Wrong side of fabric
3 Zipper teeth
4 End of zipper opening
5 3 mm (1/8 inch)
4. Remove presser foot “J”. Align the right side of the pin
in zipper foot “I” with the presser foot holder, and
attach the presser foot.
1 Right
2 Left
3 Needle drop position
CAUTION
When using zipper foot “I”, make sure the straight
stitch, middle needle position is selected. Turn the
balance wheel to make sure the needle does not
strike the presser foot. If another stitch is selected,
the needle will strike the presser foot, causing the
needle to break and possible leading to injury.
5. Set the presser foot in the 3 mm (1/8 inch) margin. Start-
ing from the end of the zipper opening. Sew to a point
about 50 mm (2 inch) from the edge of the fabric, then
stop the machine. Pull down the zipper slider, then
continue sewing to the edge of the fabric.
1 50 mm (2 inch)
2 3 mm (1/8 inch)
CAUTION
Make sure the needle does not strike the zipper
during sewing. If the needle strikes the zipper, the
needle may break, leading to injury.