Error messages -10, Caution, Error messages – Brother SuperGalaxie 3000 3000C 3000D 3100D User Manual
Page 305
9-10
Troubleshooting
CAUTION
Be sure to rethread the machine. If you
press the “Start/Stop” button without
rethreading the machine, the thread
tension may be wrong or the needle may
break and cause injury.
ERROR MESSAGES
If the machine is not properly set and the “Start/Stop” button or the “Reverse/Reinforcement Stitch”
button is pressed, or if the operation procedure is incorrect, the machine does not start. An alarm
sounds and an error message is displayed on the LCD. If an error message displays, follow the
instructions in the message.
Below is an explanation of 49 error messages. Refer to these when necessary (if you press
or do the operation correctly while the error message is displayed, the message disappears).
1.
This message is dis-
played when the motor
locks due to tangled
thread or for other
reasons relate to thread
delivery.
2.
This message is dis-
played when the presser
foot is raised and the
“Start/Stop” button,
“Reverse/Reinforcement
Stitch” button, or
“Thread Cutter” button
pushed.
3.
This message is dis-
played when the upper
thread is broken or not
threaded correctly, and
the “Start/Stop” button
or the “Reverse/
Reinforcement Stitch”
button is pressed.
4.
This message is dis-
played when the
is touched
without an embroidery
card inserted.
5.
This message is dis-
played when the
embroidery unit
initialization is started
with the presser foot
lever down.
6.
This message is dis-
played if the
is
touched when an
unusable embroidery
card is inserted.