Caution – Brother SuperGalaxie 3000 3000C 3000D 3100D User Manual
Page 44
Setting Up
1-33
2
2
1
1
1
2
3
1
2
2
3
3
1
▼
3. Pivot the spool pin so that it angles toward the front of
the machine. Set the thread spool on the spool pin so
that the thread unrolls from the front of the spool.
4. Push the spool cap onto the spool pin as far as possi-
ble, then return the spool pin to its original position.
1 Spool cap
CAUTION
• If the thread spool and/or spool cap are set
incorrectly, the thread may tangle on the spool
pin and cause the needle to break.
• Use the spool cap (large, medium, or small)
that is closest in size to the thread spool. If a
spool cap smaller than the thread spool is used,
the thread may become caught in the slit on
the end of the spool and cause the needle to
break.
Note
When sewing with fine, cross-wound thread (see the il-
lustration), use the small spool cap, and leave a small space
between the cap and the thread spool (see the illustration
at left).
1 Spool cap (small)
2 Thread spool (cross-wound thread)
3 Space
5. Hold the thread from the spool in both hands, and pass
the thread around the plate in the thread guides. Use
both hands to set the thread around the thread guide
plate.
1 Thread guide plate