Brother SuperGalaxie 3000 3000C 3000D 3100D - Manual (Page 55)

1-44 Setting Up
1 —
2 —
3 —
4 —
5 —
6 —
7 —
8 —
?!
9 —
CONTENTS
Index
6
6
1
1
2
2
3
1. Press the “Needle Position” button to raise the needle,
then turn the main power switch to OFF.
2. Lower the presser foot lever.
3. Use the screwdriver to turn the screw toward the front
of the machine and loosen the screw, then remove the
needle.
CAUTION
Do not apply pressure to the needle clamp screw. Do-
ing so may damage the needle or machine.
4. With the flat side of the needle facing the back, insert
the new needle all the way to the top of the needle
stopper (viewing window) in the needle clamp. Use a
screwdriver to securely tighten the needle clamp screw.
1 Needle stopper
2 Hole for setting needle
3 Flat side of needle
CAUTION
Be sure to push in the needle until it touches the stopper, and securely tighten the needle
clamp screw with a screwdriver. If the needle is not completely inserted or the needle
clamp screw is loose, the needle may break or the machine may be damaged.