Inserting the fabric -22 – Brother SuperGalaxie 3000 3000C 3000D 3100D User Manual
Page 197
5-22
Embroidery
1
2
3
1 Outer frame
2 Inner frame
3 Surface of fabric
1
2
3
■ Inserting the Fabric
CAUTION
If the fabric is placed loose in the embroidery frame the embroidery design will sew out
poorly. Insert the fabric on a level surface, and gently stretch the fabric tight in the frame.
Follow the steps below to insert the fabric correctly.
1. Loosen the adjustment screw on the outer embroidery
frame. Lay the fabric on the outer frame, then insert
the inner frame, clamping the fabric between the
frames.
*
Be sure to align the inner frame’s
with the outer
frame’s
.
1 Inner frame
2 Outer frame
3 Adjustment screw
2. Slightly tighten the adjustment screw, then remove the
slack of fabric by pulling on edges and corners. Do not
loosen the screw.
*
When using the large frame, tighten the adjustment
screws at the top and bottom of the frame, so that the
spaces at the top and bottom of the frame are equal.
3. Gently stretch the fabric tight, and tighten the frame
adjustment screw. This keeps the fabric from loosen-
ing after stretching.
*
After stretching the fabric, make sure the fabric is taut.
*
Make sure the inside and outside frames are even be-
fore you start embroidering.
Note
Stretch the fabric by all four corners and all four edges.
While stretching the fabric, tighten the frame adjust-
ment screw.