HP XP P9500 Storage User Manual
Page 106
If HDLM Manager, HDLM Alert Driver, and HDLM Driver are all Alive, all
the programs are running correctly.
25
.
After the installation finishes, check the path information as described in
Checking the Path Configuration on page 3-69
, and make sure that you
have successfully installed HDLM in a single-path configuration.
26
.
Connect cables to all the HBAs to change the configuration to a multi-path
configuration.
27
.
Check the path information as described in
to make sure that you have successfully
assembled a multi-path configuration.
28
.
Shut down the host.
29
.
For all the hosts that make up the cluster system, perform steps 19 to 27.
30
.
Restart each host.
31
.
Install MSCS.
32
.
Shut down each host after completing the installation of MSCS on it.
33
.
Restart each host.
34
.
Log on to Windows again as a member of the Administrators group.
35
.
Make sure that the program is working normally running properly, by
examining the results of the dlnkmgr command's view operation.
Make sure that on MSCS is displayed in Support Cluster. An example of
executing the dlnkmgr command's view operation is as follows:
PROMPT>dlnkmgr view -sys
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster : on MSCS
Elog Level : 3
Elog File Size (KB) : 9900
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(1)
Remove LU : off
Intermittent Error Monitor : off
Dynamic I/O Path Control : off(10)
HDLM Manager Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss 128
HDLM Driver Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
PROMPT>
3-38
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide for Windows
®