HP XP P9500 Storage - Manual (Page 202)

operation. Enter a period between these two parameter values. For
details about the view operation, see view (Displays Information) on page
6-32 . Leading zeros of each parameter value can be omitted; however,
when the host port number or bus number of the target HBA port is 0000,
enter 0000 or 0 for the corresponding parameter value.
Example
The following example shows how to place online all paths connected
to an HBA port whose host port number is 0001 and bus number is
0001:
PROMPT>dlnkmgr online -hba 1.1
KAPL01057-I All the paths which pass the specified HBA will
be changed to the Online status. Is this OK? [y/n]:y
KAPL01061-I 3 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
PROMPT>
-cha -pathid AutoPATH_ID
Use this parameter to place online, at one time, all the paths that pass
through a specific channel adapter port. The command will place online all
the paths that pass through the channel adapter port to which the path
with the specified AutoPATH_ID is connected. You can specify this
parameter only when the HDLM management-target device is the
Thunder 9500V series, Lightning 9900 series, Lightning 9900V series,
Hitachi USP series, Hitachi AMS2000/AMS/WMS/SMS series, HUS100
series, Universal Storage Platform V/VM series, and Virtual Storage
Platform series.
Specify the current AutoPATH_ID of the target path, which is displayed by
using the view operation. For details about the view operation, see view
(Displays Information) on page 6-32 . Leading zeros can be omitted
(000001 and 1 indicate the same AutoPATH_ID); however, when the
target AutoPATH_ID is 000000, enter 000000 or 0 for the parameter
value.
AutoPATH_IDs are re-assigned every time the host is restarted. Always
make sure that you use the view operation to find the current
AutoPATH_ID of the target path, before executing the online operation.
Example
The following example shows how to place online the paths connected
to the channel adapter port 0A. In this example, a path whose
AutoPATH_ID is 000002 is connected to the target channel adapter
port:
PROMPT>dlnkmgr online -cha -pathid 000002
KAPL01057-I All the paths which pass the specified CHA port
will be changed to the Online status. Is this OK? [y/n]:y
KAPL01061-I 2 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
PROMPT>
-pathid AutoPATH_ID
6-12
Command Reference
Hitachi Dynamic Link Manager User Guide for Windows ®