HP XP P9500 Storage - Manual (Page 112)

This command checks whether HDLM has already been installed. If
HDLM 5.4 or earlier has been installed, the KAPL09129-E message will
appear. If this happens, carry out the procedure shown in Migrating
from HDLM 5.4 or Earlier to HDLM 5.5 or Later on page 3-65 . If
HDLM 5.5 or later has been installed, the KAPL09183-E message will
appear, and then the upgrade installation or re-installation will be
performed.
After the installation is complete, go to step 15.
8
.
The program checks the MPIO driver version, and then installs the MPIO
driver. If a message appears asking you whether you want to install the
MPIO driver, make sure that no multi-path management software other
than HDLM is installed.
¢
If multi-path management software other than HDLM is installed, click
the Cancel button to cancel the installation, remove the multi-path
management software, and then install HDLM.
¢
If no multi-path management software other than HDLM is installed,
click the Next button to continue the installation.
9
.
Specify a license key file or enter a license key by following the
instructions shown in the messages that appear in the window.
If a license key file was saved in step 6, specify that license key file.
If a license key file is not being used, specify the license key directly.
10
.
Specify the installation folder by following the instructions shown in the
messages that appear in the window.
The utility for registering HDLM persistent reservation keys (dlmprsvkey)
is automatically executed. However, creation of the PRSV key might be
unsuccessful if, for example, an NIC does not exist. If the PRSV key is
created with time information only, or if key creation fails, a dialog box
will prompt you to enter the PRSV key.
If this dialog box appears, go to step 11; otherwise, go to step 13.
11
.
Enter the PRSV key by following the instructions shown in the dialog box.
The PRSV key is required for the HDLM functions to properly operate.
Also, the value of the PRSV key must be unique for each host.
12
.
If the KAPL09128-W message appears, you will need to re-enter the
correct PRSV key.
If a message does not appear, go to the next step.
13
.
The message Select Storage system to be managed. is displayed.
Click the Next button.
In a VCS environment, because an EMC DMX series or EMC CX series LU
cannot be set as an HDLM management-target device, do not select EMC
Symmetrix DMX Series, CLARiiON CX Series. Similarly, because an
HP EVA series LU cannot be set as an HDLM management-target device,
do not select HP StorageWorks EVA Series.
14
.
Follow the instructions shown in the messages that appear in the window.
¢
If a dialog box with the following text appears during installation, and
the Storport Miniport driver is being used as the HBA driver, stop the
HDLM installation. After that, install QFE838894 or a later version of
3-44
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide for Windows ®