HP XP P9500 Storage - Manual (Page 171)

When you are executing the dlnkmgr command's set operation with the -
lic parameter to install the license, you can only execute it once at a
time. If you attempt to execute more than one dlnkmgr command
containing the set operation with the -lic parameter, the following
message might appear and HDLM might terminate abnormally:
KAPL01075-E A fatal error occurred in HDLM. The system
environment is invalid.
If this message appears, execute the dlnkmgr command's view operation
with the -sys -lic parameter to make sure that the license is installed
correctly.
The following shows an example in which the command is executed:
PROMPT>dlnkmgr set -lic
KAPL01049-I Would you like to execute the operation? Operation name
= set [y/n]: y
KAPL01071-I A permanent license was installed.
PROMPT>
Viewing HDLM Version Information
This section explains how to display HDLM version information.
To display HDLM version information, execute the dlnkmgr command's view
operation with the -sys parameter specified. The following shows an example
in which the command is executed:
PROMPT>dlnkmgr view -sys
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster : off
Elog Level : 3
Elog File Size (KB) : 9900
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(1)
Remove LU : on
Intermittent Error Monitor : off
Dynamic I/O Path Control : off(10)
HDLM Manager Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss 128
HDLM Driver Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation name =
view, completion time = yyyy/mm/dd hh:mm:ss
HDLM Operation
4-11
Hitachi Dynamic Link Manager User Guide for Windows ®