HP NonStop G-Series - Manual (Page 113)

5157/5157 ACL S-Series DLT Subsystems Installation Users Guide
Operating the 5157 ACL Tape Drive 6-24
6.13 Display Error Logs
To display the error history of the module, make sure to use the
Show History menu. Access it as follows:
1. At the Default Screen, press the Enter button to enter the
Menu Mode. The Main Menu is displayed.
2. At the Main Menu, press the ü button five times until the
÷ in the display is next to ‘Show History Menu.’
3. Press the Enter button to select the submenu.
4. At the Show History Submenu, press the ü button once so
that the ÷ in the display is next to ‘Error History.’
5. Press the Enter button to select the function. A circular list
of 4-line error reports is displayed in the format shown in
Figure 6-20.
6. Using the ü and ù buttons, scroll the list to display the
error history of the module.
Fault Code: XXXX Fault Code: XXXX й й
Error Description Error Description
DD/MMM/YYY HH:MM:SS DD/MMM/YYY HH:MM:SS
Entry Entry NNNN Of NNNN NNNN Of NNNN к к
Figure 6-20 Error History Screen
6.14 Inserting and Removing Cartridges
The tape magazine must be removed from the module in order to
insert or remove cartridges. When inserting cartridges, be sure that
the slot intended for use is not already reserved in the system map
for a cartridge in a drive. The best way to avoid conflicts is to
unload the drive, either through the host computer software or by
using the Load/Unload command on the Main Menu, described
later in Section 6.22.