HP NonStop G-Series - Manual (Page 171)

5157/5157 ACL S-Series DLT Subsystems Installation/Users Guide Manual
Appendix B vi
Table B-2 (cont.)
Label Color State Operating Condition
Indicator
(Left Front Panel)
Density Override
All four right-side
or all left-side
indicators Yellow
On
Off (default)
Blinking
Blinking A density was selected from
the front panel.
Density to be selected by the
host (automatic).
The system is in Density
Selection mode.
A POST error occurred.
B.4 The Tape Cartridge
B.4.1 Cartridge Write-Protect Switch
Before loading the tape cartridge into the drive, position the
write-protect switch on the front of the cartridge
•
Left, so the cartridge is write-protected (a small orange
rectangle will be visible)
•
Right, so the cartridge is write-enabled