HP NonStop G-Series - Manual (Page 82)

5157/5157 ACL S-Series DLT Subsystems installation Users Guide
Installing and Configuring the 5157 ACL Tape Subsystem
5-9
with the system taking one space. The 68-pin SCSI terminator
(supplied with the unit) should be inserted into the right 68-pin
SCSI port on the back panel of the last unit in the chain to
terminate.
5.4.4 Connect the Power Cord
To connect the power cord:
1. Ensure the 5157 ACL power switch is set to 0.
2. Connect the power cord to the 5157 ACL power connector
ensuring that it is fully seated.
3. Connect the other end of the power cord to a nearby AC outlet.
Note: The 5157 ACL does not have protection against lightning
surges. For this reason, those customers located in high risk areas
should use external surge protection rated for use in their location
and be able to handle the power demand of the tape drive cabinet.
5.5 Setting Up Reserved Slots
Note: This function can only be used in Random Mode. The host
must have the library software installed for Random Mode to work.
One of the reserved slots can be used for a cleaning cartridge in
order to use the Autoclean function; however, this function can
only be used while operating in Random Library Mode in
conjunction with host software, such as TSI’s Auto Cartridge
Loader Media Manager (ACLMM).
1. As shown in Figures 5-3 through 5-5, navigate from the Default
screen through the Main Menu to the Configure Submenu.