HP NonStop G-Series - Manual (Page 139)

5157/5157 ACL S-Series DLT Subsystems Installation/Users Guide
Installing and Configuring the 5157/5157 ACL Digital Linear Tape Subsystem
for S-Series Servers
7-14
Example 1: Defining and Adding a Tape Drive
Use the SCF ADD TAPE command to define and add a 5157 ACL
tape drive to the system configuration.
Before the ADD TAPE command is issued, insure that the tape
drive is installed properly.
The following example adds a 5157 ACL Digital Linear Tape
subsystem, “$TAPE0” to the system configuration.
->ADD TAPE $TAPE0, SENTO STORAGE, LOCATION
(1,1,55), DEVICEID 5, &
->PRIMARYCPU 0, BACKUPCPU 1,
The following are notes about this example:
•
The LOCATION attribute specifies the location (group,
module, slot) of the PMF CRU (adapter) to which the tape
drive is attached.
•
The PRIMARYCPU attribute specifies the processor in which
the primary tape process should execute.
•
The BACKCPU attribute specifies the processor in which the
tape process starts its backup process.
•
The PRODUCT attribute specifies the product number that
identifies the model of the tape drive.