HP NonStop G-Series - Manual (Page 152)

5157/5157 ACL S-Series Subsystems Installation/Users Guide
Maintenance for the 5157 ACL
8-5
3. Press the Enter button once to select Clean Drive. The following
screen appears:
Cleaning: Cleaning:
ч ч* DLT1 * DLT1
Using Using
*Slot1 *Slot1
Figure 8-3 Maintenance Submenu
4. Line 2 is not scrollable. Press the Enter button once to accept
DLT1. The ÷ moves to line 4 of the display. The choices
available on Line 4 are slots 1 through 5, or 1 through 10. Press
the Enter button again to use the cartridge in Slot 1.
Note: If slot 1 is unable to be used for the cleaning cartridge, scroll
to line 4 to select another slot. If reserved slots have been set up,
line 4 will refer to ‘Cleaning Slot 1’, which is the first reserved
slot.
5. The Clean Confirmation Screen appears, as shown below:
Clean: DLT1 Clean: DLT1
Use: Slot1 Use: Slot1
ENTER To Execute ENTER To Execute
ESCAPE To Cancel ESCAPE To Cancel
Figure 8-4 Cleaning Confirmation Screen
6. As the confirmation screen indicates, to execute the cleaning
operation, press the Enter button. If the confirmation screen does
not show the intended drive and cleaning cartridge, press the
Escape button to return to the Cleaning submenu.