HP NonStop G-Series - Manual (Page 43)

The 5157/5157 ACL S-Series Subsystems Installation/Users Guide
Installing and Configuring the 5157 Tape Drive
3-4
3.3 Install the Subsystem
To install the 5157 tape drive:
Step Action
1
2
3
4 Note the 5157 tape drive factory settings.
Review Section 3.4.1.
Configure the 5157 tape drive for use on the system:
If the installer needs to… See section
Disable parity checking 3.4.2
Change the SCSI ID 3.4.3
Connect the cables. 3.5
3.4 Configure the 5157 Tape Drive
This section describes how to configure the 5157 tape drive
including:
•
Configuration Guidelines
•
Disable Parity Checking
•
Changing the SCSI ID
The 5157 tape drive is factory set to SCSI ID 5 unless otherwise
specified. The drive is factory set for parity generation and
checking is enabled.