HP Switch SFP Modules - Manual (Page 36)

Managing H3C LSW1FC4P0 Interface Card
Resetting an H3C LSW1FC4P0 Interface Card
26 59273-00 C
Resetting an H3C LSW1FC4P0 Interface Card
Resetting an H3C LSW1FC4P0 Interface Card reboots the H3C LSW1FC4P0
Interface Card using configuration parameters in memory. Depending on the reset
type, an H3C LSW1FC4P0 Interface Card reset may or may not include a Power
On Self Test or it may or may not disrupt traffic.
Table 2-5 describes the types of
H3C LSW1FC4P0 Interface Card resets.
During a hotreset operation, fabric services will be unavailable for a short period
(30-75 seconds depending on the H3C LSW1FC4P0 Interface Card model). Verify
all administrative changes to the fabric (if any) are complete before performing an
Nondisruptive Code Load and Activation (NDCLA). When upgrading firmware
across a fabric using non-disruptive activation, upgrade one H3C LSW1FC4P0
Interface Card at a time and allow 75 seconds between each H3C LSW1FC4P0
Interface Card.
Common administrative operations that change the fabric include:
 Adding, moving or removing devices attached to the H3C LSW1FC4P0
Interface Card fabric. This includes powering up or powering down attached
devices.
 Adding, moving or removing ISLs or other connections.
After an NDCLA operation is complete, management connections must be
re-initiated:
 QuickTools sessions will re-connect automatically
 Telnet sessions must be restarted manually.
Applicable Code Versions:
 Future H3C LSW1FC4P0 Interface Card code releases will be upgraded
non-disruptively unless specifically indicated in its associated release notes

An NDCLA operation to previous H3C LSW1FC4P0 Interface Card code
releases is not supported.
CAUTION!
Changes to the fabric may disrupt the NDCLA process.