HP Switch SFP Modules - Manual (Page 59)

Managing H3C LSW1FC4P0 Interface Card
Using the Event Browser
59273-00 C 49
3. Enter a frame size in the Frame Size field.
4. Enable or disable the Terminate Test Upon Error option.
5. Select a Loop Count option. The Loop Forever option runs the test until you
click the Stop Test button. The Loop Count option runs the test the number
of times you specify in the Loop Count field.
6. Select the default test pattern or enter a user-defined (hexadecimal) test
pattern.
7. Click the Start Test button to begin the next test. Observe the results in the
Test Results area.
Using the Event Browser
The Event Browser displays a list of events generated by the H3C LSW1FC4P0
Interface Card in the fabric and QuickTools. Events that are generated by
QuickTools are not saved on the H3C LSW1FC4P0 Interface Card, but can be
saved to a file during the QuickTools session.
Entries in the Event Browser ( Figure 2-27 ) are formatted by severity, time stamp,
source, type, and description. The maximum number of entries allowed in the
Event Browser is 10,000. The maximum number of entries allowed on an H3C
LSW1FC4P0 Interface Card is 1200. Once the maximum is reached, the event list
wraps and the oldest events are discarded and replaced with the new events.
Event entries from the H3C LSW1FC4P0 Interface Card, use the H3C
LSW1FC4P0 Interface Card time stamp, while event entries generated by the web
applet have a workstation time stamp. You can filter, sort, and export the contents
of the Event Browser to a file. The Event Browser begins recording when enabled
and QuickTools is running.
If the Event Browser is enabled using the Preferences dialog, the next time
QuickTools is started all events from the H3C LSW1FC4P0 Interface Card log will
be displayed. If the Event Browser is disabled when QuickTools is started and
later enabled, only those events from the time the Event Browser was enabled
and forward will be displayed.
NOTE:
If the Test Status field in the Test Results area indicates Failed, note the
POST Fault Code displayed in the Switch data window, and contact
technical support.