HP Switch SFP Modules - Manual (Page 37)

Managing H3C LSW1FC4P0 Interface Card
Configuring an H3C LSW1FC4P0 Interface Card
59273-00 C 27
To reset an H3C LSW1FC4P0 Interface Card using QuickTools, open the Switch
menu and select the Reset Switch:
 Select Hot Reset to perform a hot reset.
 Select Reset to perform a standard reset.
 Select Hard Reset to perform a hard reset.
Configuring an H3C LSW1FC4P0 Interface Card
H3C LSW1FC4P0 Interface Card configuration is divided into three areas:
chassis, network, and SNMP. Chassis configuration specifies H3C LSW1FC4P0
Interface Card-wide Fibre Channel settings. Network configuration specifies IP
settings, remote logging, and the NTP client. SNMP configuration specifies SNMP
settings and traps.
Switch Properties
To open the Switch Properties dialog, choose one of the following:
 Open the faceplate display for the H3C LSW1FC4P0 Interface Card you are
configuring. Open the Switch menu and select Switch Properties.
 Right-click an H3C LSW1FC4P0 Interface Card graphic in the faceplate
display, and select Switch Properties from the popup menu.
Table 2-5. H3C LSW1FC4P0 Interface Card Resets
Type Description
Hot Reset Resets an H3C LSW1FC4P0 Interface Card without a Power On
Self Test. This reset activates the pending firmware, but does not
disrupt H3C LSW1FC4P0 Interface Card traffic. If errors are
detected on a port during a hot reset, the port is reset automati-
cally.
Reset Resets an H3C LSW1FC4P0 Interface Card without a Power On
Self Test. This reset activates the pending firmware and it is dis-
ruptive to H3C LSW1FC4P0 Interface Card traffic.
Hard Reset Resets an H3C LSW1FC4P0 Interface Card with a Power On Self
Test. This reset activates the pending firmware and it is disruptive
to H3C LSW1FC4P0 Interface Card traffic.