HP XP7 Storage - Manual (Page 100)

¢
In the last installation window, the following message might be
output:
When you manage a host by using Global Link Manager and
Windows firewall is enabled on that host, execute the
firewall_setup command to allow a firewall exception.
If Global Link Manager will not be used to manage HDLM, you do not
need to take any action.
To manage HDLM with Global Link Manager, register Firewall
exceptions. For details, see Firewall Settings for Managing HDLM by
Using Global Link Manager on page 3-68 .
11
.
Check the results of the installation.
If you have performed an unattended installation, check the installation
results from the command prompt.
12
.
After the installation finishes, execute the dlmprsvkey utility with the -v
parameter specified.
Execute the following command:
HDLM-installation-folder\bin\dlmprsvkey -v
Make sure that the PRSV key displayed by the dlmprsvkey utility is
unique among all the other hosts in the SAN. If the PRSV key is not
unique or is not registered, or if the KAPL09131-W message appears,
execute the dlmprsvkey utility with the -r parameter specified to re-
register the PRSV key. If the PRSV key is not registered, the HDLM
functions might not properly operate. For details about the dlmprsvkey
utility, see The dlmprsvkey Utility for Registering an HDLM Persistent
Reservation Key on page 7-13 .
If you used a license key file, it will be deleted after the installation
finishes. The KAPL09115-W message will appear if deletion of this file
fails. If this happens, delete the file manually.
13
.
Shut down the host.
Leave the host in a single-path configuration until you check (in step 21)
whether HDLM has been successfully installed.
14
.
Modify the storage system settings.
Modify the storage system settings by following the procedure described
in the maintenance documentation for that particular storage system.
15
.
Start the host.
16
.
Log on to Windows again as a member of the Administrators group.
17
.
Check the log file and PRSV key.
This step is unnecessary if you have performed step 12. In this case, go
to step 18.
If you installed HDLM by performing an unattended installation and
specified y for the restart key in the installation-information settings file,
make sure that the KAPL09181-I message is output to installhdlm.log.
For details about this log file, see Notes on an Unattended Installation on
page 3-29 in Preparations for Installing HDLM by Performing an
3-32
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for Windows®) User Guide