HP XP7 Storage - Manual (Page 204)

operation. Enter a period between these two parameter values. For
details about the view operation, see view (Displays Information) on page
6-33 . Leading zeros of each parameter value can be omitted; however,
when the host port number or bus number of the target HBA port is 0000,
enter 0000 or 0 for the corresponding parameter value.
Example
The following example shows how to place online all paths connected
to an HBA port whose host port number is 0001 and bus number is
0001:
PROMPT>dlnkmgr online -hba 1.1
KAPL01057-I All the paths which pass the specified HBA will
be changed to the Online status. Is this OK? [y/n]:y
KAPL01061-I 3 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
PROMPT>
-cha -pathid AutoPATH_ID
Use this parameter to simultaneously place online all paths that pass
through a specific CHA port. The command will place online all paths that
pass through the CHA port in the path specified by the -pathid
parameter. Paths that pass through a specific physical CHA port on a
physical storage system will be online. You can specify this parameter
only when the HDLM management-target device is the Thunder 9500V
series, Lightning 9900V series, Hitachi USP series, Hitachi
AMS2000/AMS/WMS/SMS series, HUS100 series, Universal Storage
Platform V/VM series, and Virtual Storage Platform series.
Specify the current AutoPATH_ID of the target path, which is displayed by
using the view operation. For details about the view operation, see view
(Displays Information) on page 6-33 . Leading zeros can be omitted
(000001 and 1 indicate the same AutoPATH_ID); however, when the
target AutoPATH_ID is 000000, enter 000000 or 0 for the parameter
value.
AutoPATH_IDs are re-assigned every time the host is restarted. Always
make sure that you use the view operation to find the current
AutoPATH_ID of the target path, before executing the online operation.
Example
The following example shows how to place online the paths connected
to the channel adapter port 0A. In this example, a path whose
AutoPATH_ID is 000002 is connected to the target channel adapter
port:
PROMPT>dlnkmgr online -cha -pathid 000002
KAPL01057-I All the paths which pass the specified CHA port
will be changed to the Online status. Is this OK? [y/n]:y
KAPL01061-I 2 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
PROMPT>
-pathid AutoPATH_ID
6-12
Command Reference
Hitachi Dynamic Link Manager (for Windows®) User Guide