HP XP7 Storage - Manual (Page 125)

Installing MSCS after an HDLM installation
To install HDLM and then MSCS:
1
.
Shut down all the hosts.
2
.
Make sure that all the hosts that make up the cluster system have been
fully shut down.
3
.
Restart each host.
Restart them all in the single path configuration.
4
.
Log on to Windows as a member of the Administrators group.
5
.
Save the license key file directly under the Windows installation-
destination drive. Also, instead of using the license key file, you can
directly specify a license key during the installation of HDLM.
installation-drive:\hdlm_license
The license key file will be deleted after the installation finishes.
6
.
Perform the installation.
¢
If you are not performing an unattended installation, insert the DVD
into the drive.
In the displayed window, click the Install button next to for
Windows of Hitachi Dynamic Link Manager.
If no window is displayed, manually run the installer (setup.exe).
The program checks whether HDLM has already been installed. If the
KAPL09173-W message appears, perform the procedure shown in
Upgrade Installation or Re-installation of HDLM on page 3-64 .
If a message does not appear, go to the next step.
¢
If you are performing an unattended installation, execute the
installhdlm utility.
At the command prompt, execute the following command:
drive-containing-the-inserted-installation-DVD:\HDLM_Windows
\DLMTools\installhdlm -f installation-information-settings-
file
Specify n for the restart key in the installation-information settings
file.
This command checks whether HDLM has already been installed. If
the KAPL09183-I message appears, the re-installation will be
performed.
After the installation is complete, go to step 11
7
.
Specify a license key file or enter the license key by following the
instructions shown in the messages that appear in the window.
¢
If a license key file was saved in step 5, specify that license key file.
¢
If a license key file is not being used, specify the license key directly.
8
.
Specify the installation folder by following the instructions shown in the
messages that appear in the window.
Creating an HDLM Environment
3-57
Hitachi Dynamic Link Manager (for Windows®) User Guide