HP Photosmart C6340 All-in-One Printer - Manual (Page 177)

Solution 2: Make sure the paper is loaded correctly
Solution: Make sure that the paper is loaded correctly in the input tray.
For more information, see:
“Load paper” on page 63
Cause: The paper was not loaded correctly.
If this did not solve the issue, try the next solution.
Solution 3: Check the print settings
Solution: Check the print settings.
• Check the paper type setting to make sure it matches the type of paper loaded in
the input tray.
• Check the print quality setting and make sure it is not set too low.
Print the image with a high print quality setting, such as Best or Maximum dpi.
For more information, see:
• “Set the paper type for printing” on page 75
• “Change the print speed or quality” on page 76
• “Print using Maximum dpi” on page 82
Cause: The paper type or print quality settings were set incorrectly.
If this did not solve the issue, try the next solution.
Solution 4: Clean the rollers
Solution: Clean the rollers.
Make sure you have the following materials available:
• A lint-free cloth, or any soft material that will not come apart or leave fibers.
• Distilled, filtered, or bottled water (tap water might contain contaminants that can
damage the print cartridges).
To clean the rollers
1. Turn off the product and remove the power cord.
2. Press in the tab on the left side of the rear door to release the door. Remove the
door by pulling it away from the product.
Chapter 14
174 Troubleshooting
T
roub
les
hoot
ing