HP Photosmart C6340 All-in-One Printer - Manual (Page 57)

Set Bluetooth security for the HP All-in-One
You can enable the product security settings through the Bluetooth menu on the HP All-
in-One. From the Bluetooth menu, you can:
• Ensure passkey authentication prior to someone printing to the HP All-in-One from a
Bluetooth device.
• Make the HP All-in-One visible or invisible to Bluetooth devices that are within range.
This section contains the following topics:
• Set the security level
• Set the HP All-in-One to be invisible to Bluetooth devices
Set the security level
You can set the security level of the HP All-in-One to either Low or High. The default
security setting is Low. Low level security does not require authentication.
• Low: does not support authentication. No passkey is required and any Bluetooth
device within range can print to the HP All-in-One. This is the default security setting.
• High: supports authentication. You will need to enter a passkey before printing to the
HP All-in-One.
NOTE: The HP All-in-One ships with a predefined passkey that is set to four zeroes
"0000".
To set the product to require passkey authentication
1. Press Setup.
2. Press the down arrow button until Bluetooth is highlighted, and then press OK.
3. Press the down arrow button until Passkey is highlighted, and then press OK.
4. Use the visual keyboard to enter a new passkey.
NOTE: The passkey must be 1 to 4 characters long, and can only consist of
numbers.
5. When you have finished entering your passkey, press OK to view the Bluetooth
menu.
6. Press the down arrow button until Security Level is highlighted, and then press
OK.
7. Press OK to select High.
High level security requires authentication.
Passkey authentication is now set for the product.
Related topics
“Enter text using the visual keyboard” on page 14
Chapter 4
54 Finish setting up the HP All-in-One
Finish set
up