HP Photosmart C6340 All-in-One Printer - Manual (Page 46)

General network settings
The following table describes the general network settings shown on the network
configuration page.
Parameter Description
Network Status Status of the HP All-in-One:
• Ready: The HP All-in-One is ready to receive or transmit data.
• Offline: The HP All-in-One is not currently connected to the network.
Active connection
type Network mode of the HP All-in-One:
• Wired: The HP All-in-One is connected by Ethernet cable to an IEEE
802.3 network.
• Wireless: The HP All-in-One is connected to a wireless (802.11) network.
• None: There is no network connection.
URL The IP address of the Embedded Web Server.
NOTE: You will need to know this URL when you try to access the
Embedded Web Server.
Firmware
Revision The internal networking component and firmware revision code.
NOTE: If you call HP Support, depending on the problem, you might be
asked to provide the firmware revision code.
Hostname The TCP/IP name assigned by the installation software to the product. By
default, this is the letters HP followed by the last 6 digits of the Media Access
Control (MAC) address.
Admin Password Status of the administrator's password for the Embedded Web Server:
• Set: Password is specified. You must enter the password to make
changes to the Embedded Web Server parameters.
• Not Set: No password is set. A password is not required for making
changes to the Embedded Web Server parameters.
mDNS Some local and ad hoc networks do not use central DNS servers. They use
a DNS alternative called mDNS.
With mDNS, your computer can find and use any HP All-in-One connected
to your local area network. It can also work with any other Ethernet-enabled
product that appears on the network.
Connect to a computer 43
Finish
set
up